Diablo’s premium metal cut-off discs provide superior performance and increased productivity. Featuring a premium aluminum oxide blend, these discs cut through material faster than other cut-off discs and offer an extra-long cutting life. Diablo’s thin kerf design provides for a thin, fast cut with minimal burr formation. Unlike other bonded discs on the market, this cut-off disc is a true 0.4 in. design. Fully reinforced for use in hand-held cut-off work. Ideal for use when working in hard to reach areas.
- Pro pack consists of 15-discs for up to 33% savings
- Premium aluminum oxide blend a superior quality formulation designed for fast material removal and long cutting life
- Thin kerf design provides for a thin cut; draws less power less resistance; and allows your power tool to work at its full potential
- For use on metal applications: steel, stainless, cast iron and sheet metal
- 4-1/2 in. Dia
- Thickness: 0.040 in.
- Arbor: 7/8 in.
- Type 1: flat
- Ideal for cutting
- Tool use: angle grinder
Performed like it needed to, as its stated
Did the curbside pick up and it was great!
Was adequate not sure it was any better than other options
Cut nice , have long life
Bought to cut stainless rivets does the job well go through a lot of them they wear out quickly but they are small and thin overall much more satisfied with these then HF cutting discs
The value pack was good, got 15 discs for the price of 10. Not sure if the value pack discs vary in quality from disks available by the piece. I could see through parts of the first disc I used after just a little use, areas that didn’t even come in contact with the metal or work. Could just be a defect in the disk I happened to start with. That said, I like the 0.040 discs because they are a little thinner than the 1/16 disks (maybe a little less robust also if that’s an issue to you) and the narrower cut seems to be easier and quicker to make than a cut with the thicker blade in heavy plate or bar material. If your making a cut in very thin material like barn tin, I’d stick with the more sturdy 1/16 inch blade. There isn’t much metal to remove in the first place, and the more robust blade seems to be a little less prone to chipping or the blade being gouged out by the thin metal. Recommend wearing a dust mask to protect against the disk and metal dust.
Good blades.expensive but last longer and less likely to explode
The discs were good quality.
Thinner cut off wheel goes through steel much quicker than the standard thickness. However it is very brittle and even a slight bump will cause the disc to fracture. Full face shield is an absolute must as these discs will shatter if they bind in the cut.
Cut off disk work fine for cutting thick ¼ inch metal with ease but anything thinner the disk would chip easily.
Buy extra. The cuts are clean, you can shape and clean up any burs, but this is a perishable product and you will need to replace. Wear the personal protection, please. Save the eyes, look for coworkers and family pets as you cut.
GREAT CUTOFF WHEEL VERY AGRESSIVE
Best cut off disc! The thin kerf helps cut better than the rest.
Item does the job as intended.does not last as long as the DeWalt disk.
They worked as expected
They don’t last very long.
For me they work better than the diamond cut off wheels