DEWALT FLEXVOLT 60-Volt MAX Cordless Brushless 8-1/4 in. Table Saw Kit with (2) FLEXVOLT 6.0Ah Batteries

All I can say is this saw works great. Very easy to move and carry by myself. Lots of power.

For only needing one 60V battery, this saw is great. The fence and blade are so accurate that I seamlessly joined three pieces of 5/4 oak together without running them through a jointer planer. The only complaint is that dewalt clearly doesn’t make a matching stand for this rig yet. I bought the one they make, and none of the mounting holes line up. I also had to drill out the mounting holes to accommodate the bigger bolts that the stand came with. Not a big deal once I got it done.

Would highly reccomend this table saw.

Love it so far. I have only made about 100-125 cuts with it, but it is awesome. Very powerful and sturdy. It has power like it was plugged in.

The table saw performed really well. I mounted it to a Dewalt Heavy Duty Rolling Table Saw Stand (DW7440RS) by removing the rubber feet, drilling the “feet”, bolting it to the stand, and with a few spacers and notches to the rubber feet, I was able to re-install them without a visible alteration. The bolts does not even show up. I also have to do a minor modification to stand to keep the saw from sliding down when the whole setup is stored. As for the saw itself, It is very portable (thanks to the modded setup instead of the recommended scissor stand), and it did well within it’s specification.The rack and pinion fence system is the main reason I picked this saw from its competitor. The measurement stays true and adjusting the fence is very easy. I would recommend it for light to medium carpentry/woodworks.I wish Dewalt kept the 10 inch blade with this design like its corded version.I tried to rip a couple of 2×4’s in half but the height of the blade only goes to 2.5 inches so I have to flip the 2×4 over after the first pass to complete the rip.The battery bugs down after only a few pass, and it would not charge right away since it gets pretty warm. I also wish they integrated the site pro modular guarding system for ease of changing the rivving knife and/or blade guard. Changing the rivving knife or the blade guard requires raising the knife all the way up, remove the throat plate, reaching inside the blade cavity, lossening the retaining nut, pushing the nut, pulling the rivving knife or blade guard out, pushing the replacement tool, tightening the retaining nut, and finally reinstalling the throat plate.The site pro modular guard system requires pulling a lever, change the safety tool, then release the lever. I would have paid an extra $50.00 to get that integrated. Dust collection is the best. The blade cavity is encased in a rigid thick fabric that adjust with the blade adjustment. Thus encasement channels 80% of the dust towards the dust port and 95% if you have a dust vacuum installed. No Dado cuts allowed on this table saw which is a bummer for those that does a lot of dado cuts. All the tools that came with the table are strategically intalled within the saw itself. Noise level is decent, the ripping width relative to the rip fence is 24 inches which makes it the widest in its category. Overall, I give this saw 4 of 5 stars because it could use a few more improvements.